Local Storage seems to be disabled in your browser.
For the best experience on our site, be sure to turn on Local Storage in your browser.
EZ Test Kits are very easy to use. Just follow the simple steps below.
Step 1 - Prepare some of the substance for analysis. Only a small amount is required (20mg approximately depending on the test).
Step 2 – lightly tap the unopened ampoule several times against a hard surface to make any particles sticking to the side of the ampoule fall downwards and shake to mix contents.
Step 3 - Hold the ampoule in one hand and snap off the top part at the fracture line.
Step 4 - Keep the ampoule in the upright position and transfer your sample into the ampoule. After this carefully place the cap on the opened ampoule making sure it is sealed. - LSD test kit and Cannabis tests have a small granule in the cap which is a catalyst and also needs to be added. - One easy method for adding your substance is simply fold a piece of paper and ‘funnel’ the substance into the test tube making sure it does not blow around in wind.
Step 5 - Allow a short time (30 seconds or so) for the sample and the reagents / granule to mix.
Step 6 - Compare the colour change (if any) with the colours on the colour chart included in the packaging. Any colour change should fully develop within 1 - 2 minutes (note that some tests such as the MDMA purity test kit can take up to 45 minutes to develop).
Step 7- When finished, place the used ampoule in a sealed bag and dispose of responsibly in a non-recycle bin.
Full instructions of use are included with every kit. Please ensure you are familiar with the instructions before using. You must accept the binding ‘Terms and Conditions’ before purchase. Enquires please use the contact us form